Загрузка...
Home Products Filtering elements For gases ECOPLAST-PE-G

Depth Filter Elements ECOPLAST-PE EFP-101-G based on ultra-high molecular weight polyethylene 

Filter elements Ecoplast-PE intended for removal of gaseous media particles larger than 1 micron and aerosols at temperatures from -60 to + 100°C.

Construction and materials

The filter material is a two- or three-ply porous hollow cylinder 250 mm in height, in which the total porosity and average pore size decreases from the inner to the outer layers. The layers are formed from powders of different dispersion of ultra-high molecular weight polyethylene (UHMWPE, TU 2211-001-98386801). Thermal bonding of powders occurs during sintering product in the mold.

Elements of any height can be manufactured as a dead end form, and the straight form. Elements 500, 750 or 1000 mm was prepared by welding two, three or four elements of a height of 250 mm through a transition piece. End and transition parts of elements made  monolithic from polypropylene and hermetically welded to the ends of the filter material.

Efficiency of retention of the particles - at least 99% at the stated rating and  the recommended  gas flow rate.

By agreement with the customer can be made single-layer filter elements or filter elements with a combination of other layers

General Information

The high thermochemical resistance enables the use of elements Ekoplast-PE for the filtration of corrosive gases at temperatures from -60 to + 100 ° C, as well as long service life due to the possibility of chemical recovery.

High mechanical strength to withstand high pressure differences in the forward and backward direction, significantly increases the service life of the elements by washing with hot water or purified stripping gas in a direction opposite to the direction of filtration, which is especially important to remove insoluble impurities.

Technical characteristics of the elements 250 mm high

Rating filtration, micron

1,0 2,0 5,0 10 20 50

Recommended gas flow rate, m³

To limit the maximum pressure drop

Filtering area, m2

0,05

Operating temperature range, °C

от -60 до +100

The maximum pressure drop in the forward and backward direction

2.0 MPa at + 20°C

0.3 MPa at + 100°C

pH range

1÷14

Sterilization

Chemical sterilization and autoclaving at a temperature of + 121 ° C for 30 minutes. Number of cycles - at least 20.

Aerodynamic characteristic of filtering elements with a height of 250 mm with different filtration ratings (t = 20°С)

Certification

  • Certificate of registration Roszdravnadzor (Ministry of Health)
    • Declaration of Conformity TR CU "On the safety of machinery and equipment"

 Example order: (Filter element Ecoplast-PE with a rating of 1 micron 250 mm high)

MARKING

EFP

101

G/1

250

R

S

 

Material code: deep from UHMWPE

Numerator: G (gas-gas)

Denominator: Filter rating, μm

Height of the working part of the element, mm

Adapter code: R; RR; A0; A7; F0; F1

Sealing material

S; E